WIP Passive / Drain

Wip Passive1
Wip Passive1
Wip Passive2

Effective local cleaning of the ChargePoint Active unit

  • Installation of simple static WIP or Drain unit offers elementary local gross decontamination
  • Economic and GMP design as there is no Passive unit seat or disc within the assembly. This ensures increased cleaning effectiveness as the surface area of the Active unit exposed to wash cycle is maximised
Enquire Now

The ability to effectively wash the product contact and sealing areas of a ChargePoint Active valve is assured with the use of our specifically design Wash In Place (WIP) Passive devices.

The WIP Passive/ Drain mimics a standard Passive by locking into the Active unit to allow it to be opened within a contained environment before the wash cycle is run. The device features an o-ring on the outer perimeter to create a liquid seal to the Active unit.

 

Some designs can also be pressure rated, accommodating recirculation, flood or high pressure washing cycles. 

 

Various configurations are available to suit the required WIP process and installation set-up:

 

WIP Passive

  • Used when the Active unit is installed upright (charging) orientation
  • Fixed sprayball coupled to wash fluid source
  • Wash fluid will drains through the active unit into the process below

 

WIP Drain Passive

  • Used when the Active unit is installed in the inverted (discharge) orientation
  • Fixed sprayball coupled to wash fluid source
  • Additional drain port allowing wash fluid to drain out of the device

 

WIP Drain

  • Used when the Active unit is installed in the inverted (discharge) orientation
  • Single drain port allowing the active unit to be utilised as a drain point from the process
  • No sprayball
Size (valve size compatibility)
Product contact material
Seal material
Spray Connection
Drain Connection (optional)
DN50 (2”) to DN300 (12”)
316L or Alloy 22.
EPDM, FKM or FFKM
Tri-Clamp
Tri-Clamp

 

Options:

Pressure / vacuum rating

HDPE construction for WIP Passive (without drain)